Bestobell-steam Universal Trap Bedienungsanleitung PDF herunterladen

3170 Wasson Road • Cincinnati, OH 45209 USA

Phone 513-533-5600 • Fax 513-871-0105

[email protected] • www.bestobellsteamtraps.com

Universal Traps

Installation & Maintenance Instructions for

Bestobell Steam Universal Traps

Warning: Bestobell Steam products must only be used, installed and repaired in accordance with these Installation

& Maintenance Instructions. Observe all applicable public and company codes and regulations. In the event of leak-

age or other malfunction, call a qualiﬁed service person; continued operation may cause system failure or a general

hazard. Prior to servicing equipment, disconnect, shut off, drain and/or bypass all pressurized ﬂuids.

Pre-Installation

1. Blow out piping to remove any scale or dirt.

2. Verify that your Bestobell steam trap will meet system

conditions by checking the nameplate for operating

differential pressure and maximum pressure and tem-

perature limits of the trap body.

3. The pipe connector (25) can be oriented in many

positions as long as the trap mounting surface is either

horizontal or vertical when the trap body is mounted.

See orientation as shown below.

4. The ﬂow arrow in the pipe connector must be in the

direction of the ﬂow, otherwise the trap will not operate

because the integral check valve will not allow ﬂow in

reverse direction.

Installation

1. Once the pipe connector has been installed, the

steam trap can be mounted to it using the two bolts

(17) with a suitable anti-seize compound applied to

them.

2. The trap should be oriented as shown in Figure 1 by

rotating the swivel ﬂange (11) to align with the bolts

in the connector. For horizontal trap mounting, the

word “TOP” on the body casting (1) should be facing

up.

3. Secure the two bolts initially by hand and then tight-

ening to 35 ft-lbs using a 9/16” wrench.

4. Be sure to check that both inner and outer gaskets

are in position before making connection.

5. Pipe connections can be purchased with strainer and

an optional integral blowdown valve.

Figure 1

Item Part Name Material Qty

1 Body CF8 SST 1

2 Body Gasket Grafoil 1

6 Control Element SST 1

9 C/E Gasket Grafoil 1

10 Snap Ring 303 SST 1

11 Swivel Flange 304 SST 1

12 Cover Bolts GR8 4

13 Cover Nuts GR8 4

16 Cover CF8 SST 1

17 Connector Bolts GR8 2

25 Connector CF8 SST 1

1 2

Inhaltsverzeichnis

Seite 1 - Installation

3170 Wasson Road • Cincinnati, OH 45209 USAPhone 513-533-5600 • Fax [email protected] • www.bestobellsteamtraps.comUniversal T

Seite 2 - Maintenance

MaintenanceThe Universal Steam Trap can be readily overhauled by replacing the Delta control element as a complete assembly. Anew factory replaceme

Kommentare zu diesen Handbüchern

Keine Kommentare

Bestobell-steam Universal Trap Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Wasserausrüstung Bestobell-steam Universal Trap herunter. Bestobell Steam Universal Trap User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Wasserausrüstung Bestobell-steam Universal Trap